AESEQ Duplicate Error SD0005

Hi David,  The SD0005 check

Hi David, 

The SD0005 check reports only duplicate records, but it does not provide a reference to original "baseline" records. Therefore it's quite difficult to perform a diagnostic only with a validation report.

I would recommend to take the original data and sort it by USUBJID and AESEQ. Then look for reported values to ensure that no duplicate records are present.

Please let us know if the false-positive messages do really exist?

Regards,

Sergiy 

Hello Sergiy,   I think that

Hello Sergiy,

I think that these false positives may exist see below

I get this error numerous times

I will send you the dataset and validation report so you can see

Thanks

Dave Borbas

Update

Hello Sergiy,

Based on your email I thought it would be worth reviewing everything.

So I checked the xpt file and noted only 922 records – OK there

Then I re-ran validation with my current version (same as before) of OpenCDISC Validator. However this time I did not see the duplicate AESEQ error.

Good – not sure what happened here. We can close this issue if it should occur again I will let you know

Thank you very much,

David, Some potential source

David,

Some potential source for this issue could be your validation set-up process. E.g., if you included the same AE file twice, then the validator could consider them as two separate split datasets and combine records from two the same sources before a validation.

Regards, 

Sergiy

OK, I've run validation with

OK, I've run validation with adding AE two times. That resulted in the same validation report as you sent me. It includes AESEQ dups for all records.

Be careful when adding datasets for validation. When you re-runnig validation within the same session, be sure that you "Clear"-ed datasets used previously.

Regards,

Sergiy